Vehicle Jacking
WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
When you are jacking the vehicle at the front locations, be certain that the jack or the jack lift pad does not contact the front fascia, front fascia air dam or the front fenders. If such contact occurs, vehicle damage may result. When jacking at selected front locations additional clearance may be required for the jacking points.
NOTE:
When you are lifting a vehicle with a service jack, block the wheels at the opposite end from which you are lifting. Use jack stands to provide additional support.
When using a service jack under the front of the vehicle use one of the following locations:
Front of Vehicle
Place the service jack pad at the front compartment side rail rear extension panel, as shown with rubber or wood block.
Rear of Vehicle
NOTE:
Place jackstands ONLY under strong and stable vehicle structures.
Place the service jack pad at the underbody rear side rail reinforcement extension panel, as shown with rubber or wood block.