LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 86 (Seat Belt System) >> Diagnostic Information and Procedures >> Seat Belt Indicator Malfunction - Rear >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
  1. Observe the scan tool parameters listed below while buckling and unbuckling the left rear, right rear and middle rear seat belts. The values for each should change from Unbuckled to Buckled.
    • 2nd Row Left Seat Belt Status
    • 2nd Row Middle Seat Belt Status
    • 2nd Row Right Seat Belt Status
    • If the values do not change, refer to Seat Belt Switch Malfunction.
  2. Command the Driver Seat Belt Reminder ON and OFF with a scan tool, the seat belt indicator should turn ON and OFF while changing between the commanded states.
    • If the indicator is always ON or always OFF, refer to Seat Belt Indicator Malfunction.
scientia non olet · About LEMON Manuals