LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 86 (Seat Belt System) >> Diagnostic Information and Procedures >> Seat Belt Indicator Malfunction - Driver >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the B153D driver seat belt buckle.
  2. Test for infinite resistance between the signal terminal 2 and the ground terminal 1 with the switch in the open position.
    • If not the specified value, replace the B153D driver seat belt buckle.
  3. Test for less than 2 Ω between the signal terminal 2 and the ground terminal 1 with the switch in the closed position.
    • If greater than the specified range, replace the B153D driver seat belt buckle.
scientia non olet · About LEMON Manuals