LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 83 (Engine Mechanical - 1.4L (LV7) - Specifications) >> Specifications >> Fastener Specifications (L5Q)

Fastener Specifications (L5Q)

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
Single Use Non-Threaded Fasteners/Components

Application
NOTE: All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. 
Camshaft Timing Chain Gasket
Crankshaft Front Oil Seal
Intake Manifold Gasket
Piston Pin Retainer
Piston Ring
Valve Stem Oil Seal
Single Use Threaded Fastener/Component Tightening Specifications

Application Specification
Metric (English)
NOTE: All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. 
Automatic Transmission Flex Plate Bolt
  • First Pass:
 30 N.m (22 lb ft)
  • Final Pass:
 70 Degrees
Camshaft Position Actuator Bolt
  • First Pass:
 20 N.m (15 lb ft)
  • Final Pass:
 90 Degrees
Connecting Rod Bolt
  • First Pass:
 25 N.m (18 lb ft)
  • Final Pass:
 75 Degrees
Crankshaft Balancer Bolt
  • First Pass:
 100 N.m (74 lb ft)
  • Final Pass:
 180 Degrees
Cylinder Head Bolt
  • First Pass:
 30 N.m (22 lb ft)
  • Final Pass:
 240 Degrees
Cylinder Head Stud 10 N.m (89 lb in)
Engine Flywheel Bolt
  • First Pass:
 30 N.m (22 lb ft)
  • Final Pass:
 70 Degrees
Engine Mount Bolt -
  • First Pass:
 58 N.m (43 lb ft)
  • Final Pass:
 60 to 75 Degrees
Lower Crankcase Bolt - Perimeter
  • First Pass:
 5 N.m (44 lb in)
  • Final Pass:
 10 N.m (89 lb in)
Lower Crankcase Bolt
  • First Pass:
 15 N.m (11 lb ft)
  • Final Pass:
 180 Degrees
Positive Crankcase Ventilation Valve Bolt 10 N.m (89 lb in)
Reusable Threaded Fastener Tightening Specifications

Application Specification
Metric (English)
NOTE: All fasteners listed in this table can be reused after removal. 
Air Conditioning Compressor Bolt 19 - 25 N.m (14 - 18 lb ft)
Air Conditioning Compressor Stud 5 - 11 N.m (44 - 97 lb in)
Air Conditioning Compressor Nut 19 - 25 N.m (14 - 18 lb ft)
Air Conditioning Compressor Stud 8 N.m (71 lb in)
Belt Idler Pulley Bolt 19 - 25 N.m (14 - 18 lb ft)
Camshaft Bearing Cap Bolt 12 N.m (106 lb in)
Camshaft Cover Bolt 15 N.m (11 lb ft)
Camshaft Cover Stud 15 N.m (11 lb ft)
Camshaft Position Actuator Solenoid Valve Bolt 10 N.m (89 lb in)
Camshaft Position Sensor Bolt 10 N.m (89 lb in)
Catalytic Converter Brace Bolt 22 N.m (16 lb ft)
Catalytic Converter Brace Nut 22 N.m (16 lb ft)
Catalytic Converter Heat Shield Bolt 9 N.m (80 lb in)
Catalytic Converter Nut 22 N.m (16 lb ft)
Catalytic Converter Stud 10 N.m (89 lb in)
Clutch Pressure Plate Cover Assembly Bolt
  • First Pass:
 20 N.m (15 lb ft)
  • Final Pass:
 To final torque
Crankshaft Oil Deflector Bolt - M6 10 N.m (89 lb in)
Crankshaft Oil Deflector Bolt - M8 25 N.m (18 lb ft)
Crankshaft Position Sensor Bolt 10 N.m (89 lb in)
Cylinder Head Core Hole Plug 25 N.m (18 lb ft)
Cylinder Head Core Hole Plug 75 N.m (55 lb ft)
Drive Belt Tensioner Bolt 49 - 67 N.m (36 - 49 lb ft)
Engine Block Coolant Drain Hole Plug 60 N.m (44 lb ft)
Engine Block Oil Gallery Plug 45 N.m (33 lb ft)
Engine Block Oil Gallery Plug 65 N.m (48 lb ft)
Engine Coolant Thermostat Housing Bolt 10 N.m (89 lb in)
Engine Control Module (ECM) Wiring Harness Ground Bolt 10 N.m (89 lb in)
Engine Front Cover Bolt - M6 - Perimeter 15 N.m (11 lb ft)
Engine Front Cover Bolt [1x] - M6 15 N.m (11 lb ft)
Engine Front Cover Bolt - M10 58 N.m (43 lb ft)
Engine Front Cover Bolt - M14 58 N.m (43 lb ft)
Engine Front Cover Hole Plug 50 N.m (37 lb ft)
Engine Front Cover Stud 15 N.m (11 lb ft)
Engine Lift Bracket Bolt 25 N.m (18 lb ft)
Engine Oil Pressure Sensor 35 N.m 29 lb ft)
Evaporative Emission Canister Purge Solenoid Valve Bolt 10 N.m (89 lb in)
Exhaust Pipe Clamp 15 N.m (11 lb ft)
Fuel Injection Fuel Rail Bolt 9 N.m (80 lb in)
Generator Bolt 19 - 25 N.m (14 - 18 lb ft)
Generator Nut 19 - 25 N.m (14 - 18 lb ft)
Generator Mounting Stud 5 - 11 N.m (44 - 97 lb in)
Ignition Coil Bolt 10 N.m (89 lb in)
Intake Manifold Bolt 10 N.m (89 lb in)
Knock Sensor Bolt 25 N.m (18 lb ft)
Manifold Absolute Pressure Sensor Bolt 6 N.m (53 lb in)
Oil Filter 3/4 to 1 full turn after gasket makes contact with the sealing surface on the filter mounting flange
Oil Filter Fitting 55 N.m (41 lb ft)
Oil Pan Bolt 10 N.m (89 lb in)
Oil Pan Drain Plug 25 N.m (18 lb ft)
Oil Pump Bolt - M6 10 N.m (89 lb in)
Oil Pump Bolt - M8 25 N.m (18 lb ft)
Oil Pump Drive Chain Cover Bolt 10 N.m (89 lb in)
Oil Pump Drive Chain Tensioner Bolt 10 N.m (89 lb in)
Oil Pump Sprocket Bolt
  • First Pass:
 10 N.m (89 lb in)
  • Final Pass:
 60 Degrees
Piston Oil Nozzle 10 N.m (89 lb in)
Spark Plug 17 N.m (13 lb ft)
Starter Bolt 58 N.m (43 lb ft)
Starter Mounting Nut 49 - 67 N.m (36 - 49 lb ft)
Starter Stud 10 N.m (89 lb in)
Thermostat Bypass Pipe Bolt 10 N.m (89 lb in)
Throttle Body Bolt 8.5 N.m (75 lb in)
Timing Chain Guide Bolt 10 N.m (89 lb in)
Timing Chain Oil Nozzle 15 N.m (11 lb ft)
Timing Chain Tensioner Bolt 25 N.m (18 lb ft)
Timing Chain Tensioner Shoe Bolt 25 N.m (18 lb ft)
Vacuum Pump Bolt
  • First Pass:
 15 N.m (11 lb ft)
  • Final Pass:
 25 N.m (18 lb ft)
Water Outlet Bolt 12 N.m (106 lb in)
Water Pump Bolt 10 N.m (89 lb in)
Water Pump Housing Bolt 25 N.m (18 lb ft)
Wiring Harness Connector Bolt 10 N.m (89 lb in)
scientia non olet · About LEMON Manuals