LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Power Steering System) >> Diagnostic Information and Procedures >> DTC C0460: Steering Wheel Angle Sensor Not Learned >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If DTC C0460 58 is set, check all connections for looseness, bent terminals, corrosion, contamination, deterioration and/or damage before starting Circuit/System Testing.
  1. Ignition ON.
  2. Verify the DTC is not set.
    • If the DTC is set 
    1. Calibrate the K43 Power Steering Control Module. Refer to Power Steering Control Module Calibration 
    2. Verify the DTC does not set while operating the vehicle within the Conditions for Running the DTC
      • If the DTC sets, replace the steering column assembly.
      • If the DTC is not set
    3. All OK.
    • If the DTC is not set 
  3. All OK.
scientia non olet · About LEMON Manuals