Front Wheel Drive Shaft Tripot Joint (Inner Joint)

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.

The front wheel drive shaft tri-pot joint is made with the tripot design without an over-extension limitation retainer.

The joint is constructed as follows for vehicles that are equipped with an automatic transmission:

The left front wheel drive axle has a female spline. The female spline installs over a stub shaft that protrudes from the transaxle.
The right front wheel drive axle has a female spline. The right front wheel drive axle uses barrel type snap rings in order to interlock with the intermediate shaft.