Circuit/System Verification
WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition - On / Vehicle - In Service Mode
- Operate the component: Rear Defogger Switch - Pressed
Verify the scan tool parameter: Rear Defogger Switch=On
- If not the specified state
Replace the component: K33 HVAC Control Module
- If the specified state
- If not the specified state
- Operate the component: Rear Defogger Switch - Pressed
Verify the component turns On and Off: Rear Defogger Indicator=On & Off
- If the component does not turn On and Off
Replace the component: K33 HVAC Control Module
- If the component turns On and Off
- If the component does not turn On and Off
- Operate the component: Rear Defogger Switch - Pressed
Verify the component turns On and Off: E18 Rear Defogger Grid
- If the component does not turn On and Off
Refer to Circuit/System Testing
- If the component turns On and Off
- If the component does not turn On and Off
- All OK.