LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (Fixed And MOVEABLE Window System) >> Diagnostic Information and Procedures >> Power Windows Malfunction (A55 Without A33) >> Component Testing >> S79D Window Switch - Driver - Test

S79D Window Switch - Driver - Test

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition/Vehicle - Off
  2. Disconnect the electrical connector: S79D Window Switch - Driver
  3. Test for infinite resistance between the test points:
    • Ignition terminal 3 & Control terminal 4 - Switch - Not Pressed
    • Ignition terminal 3 & Control terminal 5 - Switch - Not Pressed
    • Ignition terminal 3 & Control terminal 6 - Switch - Not Pressed
    • Ignition terminal 3 & Control terminal 7 - Switch - Not Pressed
    • If less than infinite resistance 

      Replace the component: S79D Window Switch - Driver

    • If infinite resistance 
  4. Test for less than 3 Ω between the test points:
    • Ground terminal 1 & Control terminal 4 - Switch - Not Pressed
    • Ground terminal 1 & Control terminal 5 - Switch - Not Pressed
    • Ground terminal 1 & Control terminal 6 - Switch - Not Pressed
    • Ground terminal 1 & Control terminal 7 - Switch - Not Pressed
    • If 3 Ω or greater 

      Replace the component: S79D Window Switch - Driver

    • If less than 3 Ω 
  5. Operate the component: Driver Left Front Window Switch - Pressed & Pulled
  6. Test for less than 3 Ω between the test points:
    • {LHD} Ignition terminal 3 & Control terminal 4
    • {LHD} Ignition terminal 3 & Control terminal 5
    • {RHD} Ignition terminal 3 & Control terminal 6
    • {RHD} Ignition terminal 3 & Control terminal 7
    • If 3 Ω or greater 

      Replace the component: S79D Window Switch - Driver

    • If less than 3 Ω 
  7. Operate the component: Right Front Window Switch - Pressed & Pulled
  8. Test for less than 3 Ω between the test points:
    • {LHD} Ignition terminal 3 & Control terminal 6
    • {LHD} Ignition terminal 3 & Control terminal 7
    • {RHD} Ignition terminal 3 & Control terminal 4
    • {RHD} Ignition terminal 3 & Control terminal 5
    • If 3 Ω or greater 

      Replace the component: S79D Window Switch - Driver

    • If less than 3 Ω 
  9. All OK.