Circuit/System Verification
WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition - On/Vehicle - In Service Mode
- S13D Door Lock Switch - Driver - Not Pressed
Verify the scan tool parameter: Driver Door Lock Switch = Inactive
- If not the specified state
Refer to: Circuit/System Testing - Test 1
- If the specified state
- If not the specified state
- Operate the component: S13D Door Lock Switch - Driver - Lock & Unlock
Verify the scan tool parameter: Driver Door Lock Switch = Lock & Unlock
- If not the specified state
Refer to: Circuit/System Testing - Test 2
- If the specified state
- If not the specified state
- S13P Door Lock Switch - Passenger - Not Pressed
Verify the scan tool parameter: Driver Door Lock Switch = Inactive
- If not the specified state
Refer to: Circuit/System Testing - Test 1
- If the specified state
- If not the specified state
- Operate the component: S13P Door Lock Switch - Passenger - Lock & Unlock
Verify the scan tool parameter: Driver Door Lock Switch = Lock & Unlock
- If not the specified state
Refer to: Circuit/System Testing - Test 2
- If the specified state
- If not the specified state
- Operate the component: S13D Door Lock Switch - Driver - Lock & Unlock
Verify the component works as specified:
- A23D Door Latch Assembly - Driver = Lock & Unlock
- A23LR Door Latch Assembly - Left Rear = Lock & Unlock
- A23P Door Latch Assembly - Passenger = Lock & Unlock
- A23RR Door Latch Assembly - Right Rear = Lock & Unlock
- If the component does not activate - A23D Door Latch Assembly - Driver
Refer to: Circuit/System Testing - Test 3
- If the component does not activate - A23LR Door Latch Assembly - Left Rear
Refer to: Circuit/System Testing - Test 4
- If the component does not activate - A23P Door Latch Assembly - Passenger
Refer to: Circuit/System Testing - Test 4
- If the component does not activate - A23RR Door Latch Assembly - Right Rear
Refer to: Circuit/System Testing - Test 4
- If none of the components operate
Refer to: Circuit/System Testing - Test 5
- If all functions work properly
- All OK.