LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Hydraulic Brake System) >> Repair Instructions >> Rear Brake Rear Pipe Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Refer to Brake Fluid Irritant Warning .

CAUTION:

Refer to Brake Fluid Effects on Paint and Electrical Components Caution .

  1. Raise and support the vehicle. Refer to Vehicle Lifting and Jacking Caution
  2. Remove the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation
  3. Clean all dirt and foreign material from the brake hose ends and the brake pipe fitting.
    4. Fig 1: Rear Brake Rear Pipe, Fittings, Rear Brake Cylinder And Rear Brake Hose
    GM4747771Courtesy of GENERAL MOTORS COMPANY
  4. Remove Rear Brake Rear Pipe Fitting (1) @ Rear Brake Hose (2)

    Cap the brake pipe fitting to prevent brake fluid loss and contamination.

  5. Remove Rear Brake Rear Pipe Fitting (3) @ Rear Brake Cylinder (4)
  6. Remove Rear Brake Rear Pipe (5) @ Vehicle
scientia non olet · About LEMON Manuals