Installation Procedure
WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
- Install the brake master cylinder reservoir, if removed. Refer to Master Cylinder Reservoir Replacement (LHD) .
- Bench bleed the brake master cylinder. Refer to Master Cylinder Bench Bleeding .
- Install the brake master cylinder (1) to the power vacuum brake booster.
- Install the brake master cylinder nuts (1) and tighten to 13 N.m (115 lb in).
- Install the EBCM/BPMV and bracket assembly. Refer to Electronic Brake Control Module with Brake Pressure Modulator Valve Replacement .
- Install the brake pressure modulator valve primary pipe. Refer to Brake Pressure Modulator Valve Primary Pipe Replacement (LHD) .
- Install the brake pressure modulator valve secondary pipe. Refer to Brake Pressure Modulator Valve Secondary Pipe Replacement (LHD) .
- Install the battery tray. Refer to Battery Tray Replacement (without Engine Block Heater)Battery Tray Replacement (with Engine Block Heater) .
- Install the engine control module. Refer to Engine Control Module Replacement .
- Install the battery. Refer to Battery Replacement .
- Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) Hydraulic Brake System Bleeding (Pressure) .
CAUTION:
Refer to Fastener Caution .