Installation Procedure
WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
- Install Front Brake Pipe (1) @ Vehicle
- Install Front Brake Pipe (1) @ Brake Pipe Clip (2)
- Install Front Brake Pipe (1) @ Brake Pipe Clip (2)
- Install Front Brake Pipe (1) @ Brake Pipe Clip (2)
- Install and tighten Front Brake Pipe Fitting (1) @ Front Brake Hose (2) to 18 N.m (13 lb ft)
- Install Fuel Feed Pipe. Refer to Fuel Feed Pipe Replacement - Underbody (L5Q)Fuel Feed Pipe Replacement - Underbody (LV7)
- Install Drivetrain and Front Suspension Frame. Refer to Drivetrain and Front Suspension Cradle Replacement .
- Install and tighten Front Brake Pipe Fitting (1) @ Brake Pressure Modulator Valve (2) to 18 N.m (13 lb ft)
- Install Brake Pressure Modulator Valve Primary Pipe. Refer to Brake Pressure Modulator Valve Primary Pipe Replacement (LHD) Brake Pressure Modulator Valve Primary Pipe Replacement (RHD)
- Install Brake Pressure Modulator Valve Secondary Pipe. Refer to Brake Pressure Modulator Valve Secondary Pipe Replacement (LHD) Brake Pressure Modulator Valve Secondary Pipe Replacement (RHD)
- Install Battery Tray. Refer to Battery Tray Replacement (without Engine Block Heater)Battery Tray Replacement (with Engine Block Heater)
- Bleed the brake system. Refer to Hydraulic Brake System Bleeding (Manual) Hydraulic Brake System Bleeding (Pressure)
- Lower the vehicle.
CAUTION:
Refer to Fastener Caution .