LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Hydraulic Brake System) >> Repair Instructions >> Front Brake Hose Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Brake Hose, Banjo Bolt And Sealing Washers
    GM4007545Courtesy of GENERAL MOTORS COMPANY
  1. Assemble the brake hose fitting banjo bolt (1) with 2 new copper brake hose sealing washers (2) to the brake hose (3).
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the brake hose assembly to the caliper and tighten the brake hose fitting banjo bolt to 40 N.m (30 lb ft).
    3. Fig 2: Brake Hose And Strut Mounted Brake Hose Retaining Bracket
    GM4007539Courtesy of GENERAL MOTORS COMPANY
  3. Install the brake hose (1) to the strut mounted brake hose retaining bracket (2).
    4. Fig 3: Brake Hose Retaining Clip
    GM4007537Courtesy of GENERAL MOTORS COMPANY
  4. Install the brake hose to the brake hose mounting bracket on the body frame.
  5. Install the brake hose retaining clip (1) to the brake hose mounting bracket.
    6. Fig 4: Brake Pipe Fitting And Brake Hose
    GM4007534Courtesy of GENERAL MOTORS COMPANY
  6. Connect the brake pipe fitting (1) to the brake hose (2) and tighten to 18 N.m (13 lb ft).
  7. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) Hydraulic Brake System Bleeding (Pressure) .
  8. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  9. Lower the vehicle.
scientia non olet · About LEMON Manuals