Installation Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Brake Pressure Modulator Primary Pipe And Brake Pipe Clips

Courtesy of GENERAL MOTORS COMPANY

Install the brake pressure modulator valve primary pipe (1) to the vehicle.
Attach the brake pressure modulator primary pipe (1) to the brake pipe clips (2).

Fig 2: Brake Pressure Modulator Valve Primary Pipe Fitting At Brake Pressure Modulator Valve

Courtesy of GENERAL MOTORS COMPANY

CAUTION:

Refer to Fastener Caution .

Connect the brake pressure modulator valve primary pipe fitting (1) to the brake pressure modulator valve and tighten to 18 N.m (13 lb ft).

Fig 3: Brake Pressure Modulator Valve Primary Pipe Fitting At Master Cylinder

Courtesy of GENERAL MOTORS COMPANY

Connect the brake pressure modulator valve primary pipe fitting (1) to the master cylinder and tighten to 18 N.m (13 lb ft).

Fig 4: EBCM And BPMV Assembly Electrical Connector

Courtesy of GENERAL MOTORS COMPANY

Connect the electrical connector (1) from the EBCM and BPMV assembly (2).
Install the battery tray. Refer to Battery Tray Replacement (without Engine Block Heater)Battery Tray Replacement (with Engine Block Heater) .
Install the engine control module. Refer to Engine Control Module Replacement .
Install the battery. Refer to Battery Replacement .

Fig 5: Fuel Feed Pipe And Retaining Clips

Courtesy of GENERAL MOTORS COMPANY

Attach the push clip (1) to the front compartment side rail and attach the fuel feed pipe (3) to the fuel feed pipe clip (2).
Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement (L5Q)Air Cleaner Outlet Duct Replacement (LV7) .
Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) Hydraulic Brake System Bleeding (Pressure) .