LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Hydraulic Brake System) >> Repair Instructions >> Brake Pressure Modulator Valve Primary Pipe Replacement (LHD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Refer to Brake Fluid Irritant Warning .

CAUTION:

Refer to Brake Fluid Effects on Paint and Electrical Components Caution .

  1. Remove the battery. Refer to Battery Replacement .
  2. Remove the engine control module. Refer to Engine Control Module Replacement .
  3. Remove the battery tray. Refer to Battery Tray Replacement (without Engine Block Heater)Battery Tray Replacement (with Engine Block Heater) .
  4. Clean all dirt and foreign material from the brake pipe fittings.
    5. Fig 1: Brake Pressure Modulator Valve Primary Pipe And Fittings
    GM4007709Courtesy of GENERAL MOTORS COMPANY
  5. Disconnect the brake pressure modulator valve primary pipe fitting (1) from the master cylinder and drain the brake fluid out of the master cylinder.
  6. Disconnect the brake pressure modulator valve primary pipe fitting (2) from the brake pressure modulator valve.
  7. Remove the brake pressure modulator valve primary pipe (3) from the vehicle.
scientia non olet · About LEMON Manuals