LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Hydraulic Brake System) >> Repair Instructions >> Brake Master Cylinder Reservoir Hose Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Brake Master Cylinder Reservoir, Hose And Clamp
    GM4747747Courtesy of GENERAL MOTORS COMPANY
  1. Install Brake Master Cylinder Reservoir Hose (2) @ Vehicle
  2. Connect Brake Master Cylinder Reservoir Hose (2) @ Brake Master Cylinder Remote Reservoir (3)
  3. Install Brake Master Cylinder Reservoir Hose Clamp (1) @ Brake Master Cylinder Reservoir Hose (2)
    4. Fig 2: Brake Master Cylinder Reservoir Hose And Retainer
    GM4747746Courtesy of GENERAL MOTORS COMPANY
  4. Install Brake Master Cylinder Reservoir Hose (1) @ Retainer (2)
    5. Fig 3: Brake Master Cylinder Reservoir, Hose And Clamp
    GM4747745Courtesy of GENERAL MOTORS COMPANY
  5. Connect Brake Master Cylinder Reservoir Hose (2) @ Brake Master Cylinder Reservoir (3)
  6. Install Brake Master Cylinder Reservoir Hose Clamp (1) @ Brake Master Cylinder Reservoir Hose (2)
  7. Bleed the brake system. Refer to Hydraulic Brake System Bleeding (Manual) Hydraulic Brake System Bleeding (Pressure) 
scientia non olet · About LEMON Manuals