LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Tire Pressure Monitoring System) >> Diagnostic Information and Procedures >> DTC C0750, C0755, C0760 or C0765: Tire Pressure Sensors >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify there are no communication DTCs set along with DTC C0750, C0755, C0760 and C0765.
    • If a communication DTC is not set 
  2. Verify the scan tool Tire Pressure Sensor Rolling Count parameter of all 4 tire pressure sensors is above 50%.
    • If the Tire Pressure Sensor Rolling Count parameter is below 50% on one or more tires 
    1. Move the appropriate tire to a different location on the vehicle and verify the Tire Pressure Sensor Rolling Count has increased. Refer to Tire and Wheel Removal and Installation .
      NOTE: When moving the tire pressure sensor to a different location on the vehicle, keep the tire pressure sensor with the original tire it is installed in.
      • If Tire Pressure Sensor Rolling Count parameter does not increase after moving tire to different location, replace the appropriate B2 Tire Pressure Sensor and perform the Tire Pressure Indicator Sensor Learn .
      • If Tire Pressure Sensor Rolling Count parameter does increase after moving tire to different location, check for any aftermarket devices that could be causing interference to the tire pressure sensor signal.
    • If the Tire Pressure Sensor Rolling Count parameter is above 50% on one or more tires 
  3. Verify if all 4 tire monitor pressure sensor DTCs are not set.
  4. Perform the Tire Pressure Indicator Sensor Learn .
  5. Verify the scan tool Tire Pressure Sensor Mode parameters change to Drive while driving the vehicle above 40 km/h (25 mph) for greater than 2 min.
    • If a Tire Pressure Sensor Mode parameter does not change to Drive 
    1. Replace the appropriate B2 Tire Pressure Sensor.
    2. Perform the Tire Pressure Indicator Sensor Learn .
    • If the Tire Pressure Sensor Mode parameter changes to Drive 
  6. All OK.
scientia non olet · About LEMON Manuals