LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Engine Mechanical - 1.4L (LV7) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Upper Oil Pan Replacement (LV7) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the exhaust muffler. Refer to Exhaust Muffler Replacement (LV7) .
  2. Remove the lower oil pan. Refer to Lower Oil Pan Replacement (LV7) .
  3. Disconnect the oil level sensor connector (1) and oil pump connector (2).
    Fig 1: Oil Level Sensor Connector And Oil Pump Connector
    GM4037015Courtesy of GENERAL MOTORS COMPANY
  4. Remove the transmission side cover and engine starter bracket bolts (1).
    Fig 2: Transmission Side Cover And Engine Starter Bracket Bolts
    GM4037008Courtesy of GENERAL MOTORS COMPANY
  5. Remove the transmission side cover (2).
  6. Remove the engine oil filter (1), using suitable tool.
    Fig 3: Engine Oil Filter
    GM4037012Courtesy of GENERAL MOTORS COMPANY
  7. Remove the 2 upper oil pan bolts (1), 11 upper oil pan bolts (2) and transmission lower bolt (3).
    Fig 4: Upper Oil Pan, Bolts And Transmission Lower Bolt
    GM4037021Courtesy of GENERAL MOTORS COMPANY
  8. Remove the upper oil pan (4).
  9. Remove the engine oil level indicator control module wiring harness bolt (1) and remove the engine oil level indicator control module wiring harness from the upper oil pan.
    Fig 5: Engine Oil Level Indicator Control Module Wiring Harness And Bolt
    GM4037050Courtesy of GENERAL MOTORS COMPANY
scientia non olet · About LEMON Manuals