Installation Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.

Remove the surge tank fixing bolts and set aside.

Fig 1: Surge Tank And Fixing Bolts
Courtesy of GENERAL MOTORS COMPANY
Install the J-36857 engine lift bracket (2) into the engine block bore.

Fig 2: Engine Lift Bracket And Bolt
Courtesy of GENERAL MOTORS COMPANY

NOTE: For engine L5Q without engine lift front bracket.
Install the bolt (1) and tighten to 25 N.m (18 lb ft).
CAUTION: Refer to Fastener Caution .
Install the EN-51007-1 adapter (1) with the EN-28467-300 engine support fixture adapter (2) on the front compartment upper side rail.

Fig 3: Engine Support Fixture Adapters
Courtesy of GENERAL MOTORS COMPANY

NOTE: A second technician is required.
Install the EN-51007-3 adapters (4) to the EN-51007-1 adapter (1) with the EN-51007-5 adapters (6) on the front end upper tie bar (2, 5).

Fig 4: Ensuring Engine Support Fixture Components Are Properly Installed
Courtesy of GENERAL MOTORS COMPANY

NOTE: The 2 feet of the rakes should be placed as far as possible in the direction as shown.
Tighten the EN-51007-3 adapters (2) to the EN-51007-1 adapter (1) by tighten it with the EN-51007-4 adapters (3).

Fig 5: Engine Support Fixture Adapters
Courtesy of GENERAL MOTORS COMPANY
Install the 3 EN-51007-6 adapters (1) into the 3 engine lift brackets (2).

Fig 6: Engine Support Fixture And Adapters
Courtesy of GENERAL MOTORS COMPANY
When the tool assembly EN-51007 support fixture is under load, adjust complete assemble and re-tighten ALL fasteners.