Assembly Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.

Install the lower foot (6) to the upper foot (5).

Fig 1: Engine Support Fixture Assembly Components
Courtesy of GENERAL MOTORS COMPANY

NOTE: Pre-assemble special tool assembly outside the vehicle.
Install the mounting bolt (3).
Install the fixing pin (4).
Install the washer (2) and tighten the nut (1).
Install the 2 EN-28467-300 adapters to the EN-51007-1 adapter.

Fig 2: Engine Support Fixture Adapters
Courtesy of GENERAL MOTORS COMPANY
Install the 2 EN-51007-4 adapters to the EN-51007-1 adapter by guiding the bail (4) into the board (1).

Fig 3: Engine Support Fixture Components
Courtesy of GENERAL MOTORS COMPANY
Install the 2 thumb nuts (2).
Install the bushing (1) to the hook (3).

Fig 4: Bushing, Lever And Hook
Courtesy of GENERAL MOTORS COMPANY
Install the lever (2) to the hook (3).
Install the EN-51007-6 adapters (1) to the EN-51007-3 adapters (2).

Fig 5: Engine Support Fixture Adapters
Courtesy of GENERAL MOTORS COMPANY
Install the foot (4) to the rod (2).

Fig 6: Foot, Rod, Bolts And Nut
Courtesy of GENERAL MOTORS COMPANY
Install and tighten the bolt (5) and the nut (3).
Install the bolt (1).
Install EN-51007-5 adapter (3) to the EN-51007-3 adapter (1).

Fig 7: Adapters, Bolt And Cotter Pin
Courtesy of GENERAL MOTORS COMPANY

NOTE: The feet should stay in the second hole of the rakes.
Install the cotter pin (4) into the bolt (2).
Check the distance between the 2 feet (1).

Fig 8: Checking Distance Between 2 Feet
Courtesy of GENERAL MOTORS COMPANY

NOTE: The distance (a) must be aligned to 1425 mm (56 in).