LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Engine Mechanical - 1.4L (LV7) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Engine Oil Level Indicator Control Module Wiring Harness Replacement (L5Q) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
  1. Engine Oil Level Indicator Control Module Wiring Harness - Install and tighten 10 N.m (89 lb in)
    Fig 1: Engine Oil Level Indicator Control Module Wiring Harness
    GM4499155Courtesy of GENERAL MOTORS COMPANY
    CAUTION: Refer to Fastener Caution .
  2. Connect the engine oil level indicator control module wiring harness connector (1) to the engine oil level indicator control module wiring harness (2).
    Fig 2: Engine Oil Level Indicator Control Module Wiring Harness Connector
    GM4499154Courtesy of GENERAL MOTORS COMPANY
  3. Crankshaft Oil Deflector (3) - Install
    Fig 3: Crankshaft Oil Deflector And Bolts
    GM4499156Courtesy of GENERAL MOTORS COMPANY
  4. Crankshaft Oil Deflector Bolt (1) [3x] Tighten in sequence 10 N.m (89 lb in)
  5. Crankshaft Oil Deflector Bolt (2) [2x] Tighten in sequence 25 N.m (18 lb ft)
  6. Oil Pan Replacement (L5Q)  - Install
scientia non olet · About LEMON Manuals