LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Engine Mechanical - 1.4L (LV7) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Engine Mount Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the engine mount (2) to the vehicle.
    Fig 1: Engine Mount And Frame Side Bracket Nuts
    GM4043900Courtesy of GENERAL MOTORS COMPANY
  2. Install the engine mount frame side bracket nuts (1) and tighten to 58 N.m (43 lb ft).
    CAUTION: Refer to Fastener Caution .
  3. Install the engine mount frame side bracket bolt (1) and tighten to 58 N.m (43 lb ft).
    Fig 2: Engine Mount Frame Side Bracket Bolt
    GM4043898Courtesy of GENERAL MOTORS COMPANY
  4. Install the NEW engine mount bolts (1) and tighten to 58 N.m (43 lb ft) + 60 to 75 degrees.
    Fig 3: Engine Mount Bolts
    GM4043897Courtesy of GENERAL MOTORS COMPANY
    CAUTION: Refer to Torque-to-Yield Fastener Caution .
  5. Place the air conditioning evaporator hose (2) to the right position and install the air conditioning evaporator tube bracket nut (1). Refer to Air Conditioning Evaporator Hose Assembly Replacement (L5Q)Air Conditioning Evaporator Hose Assembly Replacement (LV7) .
    Fig 4: Air Conditioning Evaporator Tube Bracket Nut And Air Conditioning Evaporator Hose
    GM4043896Courtesy of GENERAL MOTORS COMPANY
  6. Remove the engine support fixture. Refer to Engine Support Fixture (LV7) Engine Support Fixture (L5Q) .
  7. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
scientia non olet · About LEMON Manuals