LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Engine Mechanical - 1.4L (LV7) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Engine Mount Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the engine mount bracket (2) to the engine.
    Fig 1: Engine Mount Bracket And Bolts
    GM4043888Courtesy of GENERAL MOTORS COMPANY
  2. Install engine mount bracket bolts (1) and tighten to 58 N.m (43 lb ft) + 60 to 75 degrees.
    CAUTION: Refer to Fastener Caution .
  3. Install the engine mount. Refer to Engine Mount Replacement .
  4. Remove the engine support fixture. Refer to Engine Support Fixture (LV7) Engine Support Fixture (L5Q) .
  5. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
  6. Install the front compartment insulator. Refer to Front Compartment Insulator Replacement .
  7. Install the right front bumper fascia opening lower cover. Refer to Front Bumper Fascia Opening Lower Cover Replacement .
  8. Install the right front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
scientia non olet · About LEMON Manuals