LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Engine Mechanical - 1.4L (LV7) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Engine Lift Rear Bracket Replacement (L5Q) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the engine lift rear bracket (2).
    Fig 1: Engine Lift Rear Bracket And Bolts
    GM4036632Courtesy of GENERAL MOTORS COMPANY
  2. Install the engine lift rear bracket bolts (1) and tighten to 25 N.m (18 lb ft).
  3. Install the engine wiring harness bracket (2) and bolt (1).
    Fig 2: Engine Wiring Harness Bracket And Bolt
    GM4036631Courtesy of GENERAL MOTORS COMPANY
  4. Tighten to 9 N.m (80 lb in).
  5. Install the wiring harness retainer (1, 2, 3) to engine wiring harness bracket.
    Fig 3: Wiring Harness Retainers
    GM4036630Courtesy of GENERAL MOTORS COMPANY
  6. Close the hood.
scientia non olet · About LEMON Manuals