LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Engine Mechanical - 1.4L (LV7) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Engine Flywheel Replacement (L5Q) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the engine flywheel (1).
    Fig 1: Engine Flywheel And Bolts
    GM3763307Courtesy of GENERAL MOTORS COMPANY
    CAUTION: Refer to Crankshaft Position Sensor Reluctor Ring Caution .
  2. Install NEW 8 flywheel bolts (2).
  3. Tighten the 8 flywheel bolts (1) in sequence as shown to a first pass to 20 N.m (15 lb ft).
    Fig 2: Engine Flywheel Bolt Tightening Sequence
    GM3763309Courtesy of GENERAL MOTORS COMPANY
    CAUTION: Refer to Fastener Caution .
    CAUTION: Refer to Torque-to-Yield Fastener Caution .
    NOTE: The bolts have adhesive patch and must be tightened to final torque within 5 minutes.
  4. Tighten the 8 flywheel bolts (1) in sequence as shown to a second pass to 30 N.m (22 lb ft)
  5. Tighten the 8 flywheel bolts (1) in sequence as shown to a final pass to 70 degrees, using the EN-45059  meter.
  6. Install the clutch pressure and driven plate. Refer to Clutch Pressure and Driven Plate Replacement .
scientia non olet · About LEMON Manuals