LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Engine Mechanical - 1.4L (LV7) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Crankshaft Balancer Replacement (LV7) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the drive belt. Refer to Drive Belt Replacement (LV7) .
  2. Install the EN-44226-1  remover (2) to the crankshaft balancer (1).
    Fig 1: Crankshaft Balancer, Special Tools And Bolt
    GM3686986Courtesy of GENERAL MOTORS COMPANY
  3. Loosen the crankshaft balancer bolt (3) by counter holding the crankshaft balancer (1) with the EN-44226-1  remover (3) and suitable tool.
  4. Remove the EN-44226-1  remover.
  5. Remove the crankshaft balancer bolt.
  6. Install the EN-44226-5  protector (1) to the crankshaft (2).
    Fig 2: Protector And Crankshaft
    GM3686991Courtesy of GENERAL MOTORS COMPANY
  7. Install EN-44226-1  remover (2) and EN-44226-2  remover plate (3) onto the balancer (4).
    Fig 3: Remover Plate Assembly And Balancer
    GM3952844Courtesy of GENERAL MOTORS COMPANY
  8. Install the EN-44226-3  remover screw (1) through the EN-44226-2  remover plate and against the EN-44226-5  protector.
  9. Counter hold the EN-44226-2  remover plate and turn the EN-51368  installer screw to remove the balancer.
  10. Remove the EN-44226  remover.
  11. Remove the crankshaft balancer (4).
  12. Remove the EN-44226-5  protector.
scientia non olet · About LEMON Manuals