LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 57 (Steering Wheel And Steering Column) >> Repair Instructions >> Intermediate Steering Shaft Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the intermediate steering shaft (2) to the vehicle.
    Fig 1: Intermediate Steering Shaft Upper Bolt
    GM4024811Courtesy of GENERAL MOTORS COMPANY
  2. Connect the intermediate steering shaft (2) to the steering column shaft (3).
    NOTE: The recess of the fine tooth in the universal joint have to be precisely aligned to the recess of the fine tooth on the steering column shaft. The bore in the universal joint have to be aligned to the groove on the steering column shaft.
  3. Install the intermediate steering shaft upper bolt (1) and tighten to 34 N.m (25 lb ft).
    CAUTION: Refer to Fastener Caution .
  4. Connect the intermediate steering shaft (2) to the steering gear pinion shaft (3).
    Fig 2: Intermediate Steering Shaft Lower Bolt
    GM4024804Courtesy of GENERAL MOTORS COMPANY
    NOTE: The recess of the fine tooth in the universal joint have to be precisely aligned to the recess of the fine tooth on the steering gear pinion. The bore in the universal joint have to be aligned to the groove on the steering gear pinion.
  5. Install the intermediate steering shaft lower bolt (1) and tighten to 34 N.m (25 lb ft).
scientia non olet · About LEMON Manuals