LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 56 (Automatic Transmission - JATCO CVT) >> Repair Instructions - On Vehicle >> Transmission Rear Mount Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the transmission mount strut (2) to the cradle.
    Fig 1: Transmission Mount Strut Rear Bolt And Transmission Mount Strut
    GM4043910Courtesy of GENERAL MOTORS COMPANY
  2. Install the NEW transmission mount strut rear bolt (1) and tighten to 100 N.m (74 lb ft) + 60 to 75 degrees.
    CAUTION: Refer to Fastener Caution .
    CAUTION: Refer to Torque-to-Yield Fastener Caution .
  3. Install the NEW transmission mount strut front bolt (1) and tighten to 100 N.m (74 lb ft) + 60 to 75 degrees.
    Fig 2: Transmission Mount Strut Front Bolt
    GM4043909Courtesy of GENERAL MOTORS COMPANY
  4. Remove the jack stand.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals