LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 56 (Automatic Transmission - JATCO CVT) >> Repair Instructions - On Vehicle >> Transmission Mount Replacement - Left Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the transmission mount (3) to the vehicle.
    Fig 1: Transmission Mount Frame Side Bracket Bolts
    GM4224158Courtesy of GENERAL MOTORS COMPANY
  2. Install the transmission mount frame side bracket bolts (2) and tighten to 58 N.m (43 lb ft).
    CAUTION: Refer to Fastener Caution .
  3. Install the transmission mount frame side bracket nut (1) and tighten to 58 N.m (43 lb ft).
    Fig 2: Transmission Mount Frame Side Bracket Nut
    GM4224157Courtesy of GENERAL MOTORS COMPANY
  4. Install the NEW transmission mount bolts (1) and tighten to 58 N.m (43 lb ft) + 60 to 75 degrees
    Fig 3: Transmission Mount Bolts
    GM4224155Courtesy of GENERAL MOTORS COMPANY
    CAUTION: Refer to Torque-to-Yield Fastener Caution .
  5. Remove the engine support fixture. Refer to Engine Support Fixture (LV7)Engine Support Fixture (L5Q) .
  6. Install the battery tray. Refer to Battery Tray Replacement (without Engine Block Heater)Battery Tray Replacement (with Engine Block Heater) .
  7. Install the engine control module. Refer to Engine Control Module Replacement .
  8. Install the battery. Refer to Battery Tray Replacement (without Engine Block Heater)Battery Tray Replacement (with Engine Block Heater) .
scientia non olet · About LEMON Manuals