Conditions for Running the DTC
WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
- Battery Voltage= 9-32 V
- System Voltage= 9-32 V
- DTCs run continuously when the above conditions are met.
DTC P0741
- DTC P0717 = Not set
- Torque Converter Clutchlock-up =commanded ON
- TCC Pressure Control Solenoid Valve Command=200 kPa (29 PSI)
DTC P0742
- DTC P0717 = Not set
- Engine Speed=Less than 1500 RPM
- TCC Slip Speed=Less than 100 RPM
- Lock-up coast learning has been experienced at least once in the drive cycle.
DTC P0796, P0797, P02714, P02715
- DTC P0705, P0706, P0721, P0792, P0796, P0797, P2714, P2715, U0100 = Not set
- Engine Speed=Greater than 550 RPM
- Transmission Output Speed=Greater than 300 RPM
- Secondary Pulley Speed =Greater than 300 RPM
- Transmission Gear/Transmission Range= D or L
- Accelerator Pedal Position= Greater than 7.8% - DTC P0796, P2714 DTC P0797 - Condition 2 & DTC P2715 - Condition 2
- Vehicle Deceleration / Braking - DTC P0797 - Condition 1 & DTC P2715 - Condition 1
- Auxilliary gear box =1st Gear - DTC P0796, P2714
- Auxilliary gear box =2nd Gear - DTC P0797, P2715
- Vehicle Speed = Greater than 10 km/h (6 MPH) - DTC P0797, P2714, P2715