LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 56 (Automatic Transmission - JATCO CVT) >> Diagnostic Information and Procedures >> DTC P0601-P0604 or P0606: Control Module (MR8) >> Conditions for Setting the DTC

Conditions for Setting the DTC

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.

The transmission control module has detected an internal malfunction.

DTC P0601 

The read only memory (ROM) or the masked ROM, of the transmission control module has failed the Checksum test indicating that the data is not currently valid.

DTC P0602 

No application/calibration software found or calibration incompatible with application.

DTC P0603 

The transmission control module has failed a Long Term Memory (Flash ROM) Reset test when comparing the calculated value stored in the flash ROM in the transmission with the value stored in the transmission control module.

DTC P0604 

The random access memory (RAM) of the transmission control module has failed an operational test indicating that some portions of RAM are non-functional.

DTC P0606 

The transmission control module has failed an operational test indicating a processor performance failure between the primary and secondary processors.