LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Manual Transmission - Y4A/Y4M (MR7)) >> Repair Instructions - On Vehicle >> Transmission Mount Bracket Replacement - Left Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the transmission mount bracket (2) to the transmission.
    Fig 1: Transmission Mount Bracket And Bolts
    GM4043921Courtesy of GENERAL MOTORS COMPANY
  2. Install the NEW transmission mount bracket bolts (1) and tighten to 58 N.m (43 lb ft) + 60 to 75 degrees.
    CAUTION: Refer to Fastener Caution .
    CAUTION: Refer to Torque-to-Yield Fastener Caution .
  3. Install the transmission mount. Refer to Transmission Mount Replacement - Left Side .
  4. Remove the engine support fixture. Refer to Engine Support Fixture (LV7)Engine Support Fixture (L5Q) .
  5. Install the battery tray. Refer to Battery Tray Replacement (without Engine Block Heater)Battery Tray Replacement (with Engine Block Heater) .
  6. Install the engine control module. Refer to Engine Control Module Replacement .
  7. Install the battery. Refer to Battery Replacement .
scientia non olet · About LEMON Manuals