Installation Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.

Position the shift lever and the selector lever cable assembly in the vehicle.
Gently pull the shift lever and the selector lever cable assembly through the cowl into the engine compartment.
Install the shift lever and selector lever cable grommet nut (1) and tighten to 6 N.m (53 lb in).

Fig 1: Shift Lever And Selector Lever Cable Grommet Nuts
Courtesy of GENERAL MOTORS COMPANY

CAUTION: Refer to Fastener Caution .
Install the shift lever and selector lever cable (2) to the selector and shift lever cable bracket (4).

Fig 2: Shift Lever And Selector Lever Cable, Shift Control Housing And Selector And Shift Lever Cable Bracket
Courtesy of GENERAL MOTORS COMPANY
Install the shift lever and selector lever cable (1) to the shift control housing (3).
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
Install the shift lever and selector lever cable bracket nuts (1) to the underbody and tighten to 6 N.m (53 lb in).

Fig 3: Shift Lever And Selector Lever Cable Bracket Nuts
Courtesy of GENERAL MOTORS COMPANY
Lower the vehicle.
Install the shift lever and selector lever cable (2) to the transmission control housing.

Fig 4: Shift Lever And Selector Lever Cable, Shift Control Housing And Selector And Shift Lever Cable Bracket
Courtesy of GENERAL MOTORS COMPANY
Connect the shift lever and selector lever cable (1) to the transmission control lever.
Install the front floor console. Refer to Front Floor Console Replacement .
Install the battery tray. Refer to Battery Tray Replacement (without Engine Block Heater)Battery Tray Replacement (with Engine Block Heater) .