LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Manual Transmission - Y4A/Y4M (MR7)) >> Diagnostic Information and Procedures >> DTC P080A: Clutch Pedal Position (CPP) Not Learned >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON.
  2. Verify DTC P0651, P0806, P0807 or P0808 is not set.
    • If DTC P0651, P0806, P0807 or P0808 is not set 
  3. Perform the clutch pedal position sensor learn procedure.
    • If the clutch pedal position sensor learn was not successful 

      Refer to Circuit/System Testing.

    • If the clutch pedal position sensor learn was successful 
  4. Ignition ON.
  5. Verify DTC P080A ran and passed this ignition cycle. Operate the vehicle within the conditions for running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records.
    • If the scan tool indicates DTC P080A failed 

      Refer to Circuit/System Testing.

    • If the scan tool indicates DTC P080A ran and passed this ignition cycle 
  6. All OK.
scientia non olet · About LEMON Manuals