Conditions for Running the DTC
WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
- DTC P0010, P0011, P0013, P0014, P0016, P0017, P0068, P00C8, P00C9, P0101, P0102, P0103, P0106, P0107, P0108, P0111, P0112, P0113, P0114, P0117, P0118, P0119, P0122, P0123, P0191, P0192, P0193, P0222, P0223, P0335, P0336, P0340, P0341, P0365, P0366, P0601, P0604, P0606, P0651, P16A0, P16A1, P16A2, P16F3, P2101, P2135, P2227, P2228, P2229, or P2230 is not set.
- The engine speed is less than 1,000 RPM and DTC P0315 is set.
- The engine speed is greater than 1,400 RPM.
- The crankshaft position and camshaft position sensors are synchronized.
- The engine coolant temperature (ECT) is between -7 and 127°C (19 - 261°F).
- If the ECT is colder than -7°C (19°F) at start-up, this diagnostic will not run until the ECT is between 21 - 127°C (70 - 261°F).
- The battery voltage is between 9 - 32 V.
- The vehicle is not in a acceleration or deceleration condition.
- The ECM is not detecting a rough road signal.
- The fuel level is at least 11%.
- The ECM is not in fuel cut-off or deceleration fuel cut-off mode.
The DTCs run continuously when the above conditions are met.