LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Engine Controls And Fuel - 1.4L (LV7) - DTC P0010 To DTC P0366) >> Diagnostic Information and Procedures >> DTC P0116: Engine Coolant Temperature (ECT) Sensor Performance >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON.
  2. Verify the scan tool ECT Sensor parameter is between -39 to + 120°C (-38 to +248°F) and changes with engine run time.
    • If not between -39 to + 120°C (-38 to +248°F) or does not change 

      Refer to Circuit/System Testing.

    • If between -39 to + 120°C (-38 to +248°F) and changes 
  3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  4. Verify the DTC does not set.
    • If the DTC sets 

      Refer to Circuit/System Testing.

    • If the DTC does not set 
  5. All OK.
scientia non olet · About LEMON Manuals