Removal Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.

Remove the throttle body assembly from the engine. Refer to Throttle Body Assembly Replacement (L5Q)Throttle Body Assembly Replacement (LV7) .
Remove the clutch master cylinder reservoir hose from the clutch master cylinder. Refer to Clutch Master Cylinder Reservoir Hose Replacement (Right Hand Drive) .
Remove the retaining clip (1).

Fig 1: Clutch Actuator Cylinder Front Pipe And Retaining Clip
Courtesy of GENERAL MOTORS COMPANY
Disconnect the clutch actuator cylinder front pipe (2) from the clutch master cylinder.
Remove the 2 clutch master cylinder mount nuts (1).

Fig 2: Clutch Master Cylinder Mount Nuts
Courtesy of GENERAL MOTORS COMPANY
Remove the clutch pedal return spring. Refer to Clutch Pedal Return Spring Replacement (Right Hand Drive) .
Remove the clutch pedal position sensor. Refer to Clutch Pedal Position Sensor Replacement .
Disconnect the clutch master cylinder push rod from the clutch pedal (3), using the DT-50894 remover (2) along with the DT-6202-B pliers (1).

Fig 3: Clutch Pedal & Push Rod Removal Tools
Courtesy of GENERAL MOTORS COMPANY
Remove the clutch master cylinder in the direction of the engine compartment.