Removal Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.

Remove the battery tray. Refer to Battery Tray Replacement (without Engine Block Heater)Battery Tray Replacement (with Engine Block Heater) .
Remove the brake pressure modulator valve bracket. Refer to Brake Pressure Modulator Valve Bracket Replacement .
Remove the clutch master cylinder reservoir hose from the clutch master cylinder. Refer to Clutch Master Cylinder Reservoir Hose Replacement (Left Hand Drive) .
Remove the clutch actuator cylinder front pipe (2) from the retainers (1).

Fig 1: Clutch Actuator Cylinder Front Pipe And Retainers
Courtesy of GENERAL MOTORS COMPANY
Remove the retaining clip (1).

Fig 2: Clutch Actuator Cylinder Front Pipe And Retaining Clip
Courtesy of GENERAL MOTORS COMPANY
Disconnect the clutch actuator cylinder front pipe (2) from the clutch master cylinder.
Remove the 2 clutch master cylinder mount nuts (1).

Fig 3: Clutch Master Cylinder Mount Nuts
Courtesy of GENERAL MOTORS COMPANY
Remove the clutch pedal return spring. Refer to Clutch Pedal Return Spring Replacement (Left Hand Drive) .
Remove the clutch pedal position sensor. Refer to Clutch Pedal Position Sensor Replacement .
Disconnect the clutch master cylinder push rod from the clutch pedal (2), using the DT-6202-B pliers (1).

Fig 4: Clutch Master Cylinder, Push Rod And Special Tool
Courtesy of GENERAL MOTORS COMPANY
Remove the clutch master cylinder (3) in the direction of the engine compartment.