LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Manual Transmission Clutch) >> Repair Instructions >> Clutch Actuator Cylinder Front Pipe Replacement (Right Hand Drive) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Refer to Brake Fluid Irritant Warning .
CAUTION: Refer to Brake Fluid Effects on Paint and Electrical Components Caution .
  1. Remove the battery tray. Refer to Battery Tray Replacement (without Engine Block Heater)Battery Tray Replacement (with Engine Block Heater) .
  2. Remove the brake pressure modulator valve bracket. Refer to Brake Pressure Modulator Valve Bracket Replacement .
  3. Place basin underneath.
  4. Remove the clutch actuator cylinder front pipe (2) from the retainers (1).
    Fig 1: Clutch Actuator Cylinder Front Pipe And Retainers
    GM4010376Courtesy of GENERAL MOTORS COMPANY
  5. Remove the retaining clip (1).
    Fig 2: Clutch Actuator Cylinder Front Pipe And Retaining Clip
    GM4010442Courtesy of GENERAL MOTORS COMPANY
  6. Disconnect the clutch actuator cylinder front pipe (2) from the clutch master cylinder.
  7. Remove the retaining clip (1).
    Fig 3: Clutch Actuator Cylinder Front Pipe And Retaining Clip
    GM4010383Courtesy of GENERAL MOTORS COMPANY
  8. Disconnect the clutch actuator cylinder front pipe (2) from the clutch actuator cylinder pipe elbow.
  9. Remove the clutch actuator cylinder front pipe from the vehicle.
scientia non olet · About LEMON Manuals