Installation Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.

Install the clutch actuator cylinder front pipe in the vehicle.
Connect the clutch actuator cylinder front pipe (2) to the clutch actuator cylinder pipe elbow.

Fig 1: Clutch Actuator Cylinder Front Pipe And Retaining Clip
Courtesy of GENERAL MOTORS COMPANY
Install the retaining clip (1).
Connect the clutch actuator cylinder front pipe (2) to the clutch master cylinder.

Fig 2: Clutch Actuator Cylinder Front Pipe And Retaining Clip
Courtesy of GENERAL MOTORS COMPANY
Install the retaining clip (1).
Install the clutch actuator cylinder front pipe (2) to the retainers (1).

Fig 3: Clutch Actuator Cylinder Front Pipe And Retainers
Courtesy of GENERAL MOTORS COMPANY
Install the brake pressure modulator valve bracket. Refer to Brake Pressure Modulator Valve Bracket Replacement .
Bleed the hydraulic clutch system. Refer to Hydraulic Clutch System Bleeding .
Install the battery tray. Refer to Battery Tray Replacement (without Engine Block Heater)Battery Tray Replacement (with Engine Block Heater) .