Cable Seal Terminals
WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
- Cut off the terminal between the core and the insulation crimp to minimize any wire loss.
- Remove the old seal.
- Apply the correct cable seal, per the wire gauge size, from the kit. Slide the seal back along the wire to enable removal of the insulation.
- To minimize wire loss, remove only the insulation required.
- Using the connector end view, determine the correct crimp tool and crimp jaw.
- Align the seal with the end of the cable insulation.
- Position the stripped wire and seal in the terminal.
- Hand Crimp the core wings first.
- Hand Crimp the insulation wings around the seal and the cable.