LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Wiring Systems And Power Management - Repair Instructions) >> Repair Instructions >> Molex Connectors (SIR) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
  1. The CPA should be approximately 4 mm above the yellow cover before installing the connector. If not, use a small flat-bladed tool to help release the CPA. The CPA may also be released manually without any tools.
    Fig 1: Lifting Orange CPA
    GM2374626Courtesy of GENERAL MOTORS COMPANY
  2. Line up the connector key tabs with the initiator key slots. Grab the connector on both sides and push down into the initiator connector sub assembly until fully seated.
    Fig 2: Seating Connector Sub-Assembly
    GM3258546Courtesy of GENERAL MOTORS COMPANY
  3. After the connector is fully seated, push the CPA down with your thumb until the CPA is touching the yellow cover on the connector.
    Fig 3: Pushing CPA Down
    GM3258548Courtesy of GENERAL MOTORS COMPANY
scientia non olet · About LEMON Manuals