Terminal Removal Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.

While depressing the lock, twist and remove the connector from the component.

Fig 1: View Of Connector & Lock
Courtesy of GENERAL MOTORS COMPANY
Locate the terminal position assurance (TPA).

Fig 2: View Of Terminal Position Assurance (TPA)
Courtesy of GENERAL MOTORS COMPANY
Use a small flat-blade tool to push the TPA until it bottoms out.

Fig 3: View Of TPA & Flat-Bladed Tool
Courtesy of GENERAL MOTORS COMPANY

NOTE: The TPA cannot be removed from the connector while there are terminals present in the connector body.
Use the J-38125-28 tool to release the terminals by inserting the tool into the terminal cavity as shown in the graphic.

Fig 4: Using J 38125-28 Tool To Release Terminals
Courtesy of GENERAL MOTORS COMPANY
While holding the removal tool in place, gently pull the wire out of the back of the connector. Always remember never use force when pulling a terminal out of a connector.
Repair the terminal by following the Repairing Connector Terminals (Terminated Lead Repair) Repairing Connector Terminals (Terminal Repair) procedure.