Removal Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The orange or yellow connector position assurance (CPA) must be released first to disconnect or to connect the connector.

Lift the orange or yellow CPA vertically (avoid lifting on an angle to the connector) approximately 4 mm to release the connector. Use a small flat-bladed tool to help release the CPA. The CPA may also be released manually without any tools.

Fig 1: Lifting Orange CPA
Courtesy of GENERAL MOTORS COMPANY
Grab the connector on both sides and lift vertically to disconnect the connector.

Fig 2: Grabbing Connector On Both Sides
Courtesy of GENERAL MOTORS COMPANY