LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Wiring Systems And Power Management - Repair Instructions) >> Repair Instructions >> Bosch Connectors (BSK) >> Terminal Removal Procedure

Terminal Removal Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the connector from the component.
  2. Remove the wire dress cover, if necessary.
  3. Push the wire side of the terminal that is being removed toward the connector and hold it in position.
  4. Insert the J-38125-561  tool into the 2 cavities on each side of the terminal at the front of the connector and push until you feel the tool disengage the terminal retainers.
    Fig 1: View Of Bosch Connector Terminals (BSK)
    GM1446346Courtesy of GENERAL MOTORS COMPANY
  5. Carefully pull the terminal out of the connector. Always remember never use force when pulling a terminal out of a connector. If the terminal is difficult to remove, repeat the entire procedure.
  6. Repair the terminal by following the Repairing Connector Terminals (Terminated Lead Repair) Repairing Connector Terminals (Terminal Repair)  procedure.
  7. Insert the repaired terminal back into the cavity. Repeat the diagnostic procedure to verify the repair and reconnect the connector bodies.
scientia non olet · About LEMON Manuals