LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Wiring Systems And Power Management - Repair Instructions) >> Repair Instructions >> Bosch Connectors (0.64) >> Terminal Insertion Procedure

Terminal Insertion Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
  1. Prior to installation the terminal must be aligned so the (1) coding lugs align with the (2) coding grooves on the connector.
    Fig 1: Aligning Coding Lugs With Connector Coding Grooves
    GM1442741Courtesy of GENERAL MOTORS COMPANY
  2. Once the terminal is aligned, slide the terminal into the cavity until the retainer has engaged in the cavity of the connector.
  3. Slide the TPA in the connector body and seat it using a small flat bladed tool. The TPA is seated when it is flush with the contact housing.
  4. Secure the wires to the connector body using a tie wrap and replace the dress cover and grommet.
scientia non olet · About LEMON Manuals