LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Engine Controls And Fuel - 1.4L (LV7) - DTC P0351 To DTC P2544 And Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Service Bay Test (LV7) >> Test Procedure

Test Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • If the Service Bay Test aborts or fails, a DTC will NOT be set.
  • You must not rush the scan tool selections or erroneous results or error messages could occur.
  1. Select the Service Bay Test with the scan tool.
    2. WARNING:

    Refer to Road Test Warning .

  2. Follow the instructions on the scan tool. The EVAP Service Bay Test should complete and should not abort or fail.
    • If the test aborts 

      Correct the condition for running the test, then retest.

      or

    • If the test fails 

      Repair the vehicle for the condition indicated by the failure message, then retest.

    • If the test passes 
      NOTE:

      There are several test parameters displayed and can vary by engine RPO.

  3. Verify that the EVAP Monitor Complete parameter, is set to YES.
scientia non olet · About LEMON Manuals