LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Engine Controls And Fuel - 1.4L (LV7) - DTC P0351 To DTC P2544 And Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Malfunction Indicator Lamp (MIL) Diagnosis (Lamp Controlled by Serial Data) >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the P16 Instrument Cluster, ignition ON.
  2. Verify a test lamp illuminates between the Ignition voltage circuit terminal 19 and ground.
    • If the test lamp does not illuminate and the circuit fuse is good 
    1. Ignition OFF.
    2. Test for less than 2 Ω in the ignition voltage circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, verify the fuse is not open and there is voltage at the fuse.
    • If the test lamp does not illuminate and the circuit fuse is open 
    1. Ignition OFF.
    2. Test for infinite resistance between the ignition voltage circuit and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
      • If infinite resistance, test all components connected to the ignition voltage circuit and replace as necessary.
    • If the test lamp illuminates 
  3. Replace the P16 Instrument Cluster.
scientia non olet · About LEMON Manuals