Conditions for Running the DTC

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.

DTC P0010, P2088 or P2089 is not set.
Ignition voltage is greater than 11 V.
Engine is running.
Desired camshaft position is greater than 0°.
Both of the desired and actual camshaft position actuator values are greater than 0° and less than 32.5°.
Desired camshaft position variation is less than 3° for at least 1 s.

The DTC runs continuously when the above conditions are met.