LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Engine Controls And Fuel - 1.4L (LV7) - DTC P0351 To DTC P2544 And Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0496: Evaporative Emission (EVAP) System Flow During Non-Purge >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, engine OFF.
  2. Seal the EVAP system using the Purge/Seal function with a scan tool.
  3. Start the engine.
  4. Observe the fuel tank pressure sensor with a scan tool. The Fuel Tank Pressure Sensor parameter should be less than 1.7 V after 90 s.
    • If not within specifications 

      Replace the Q12 Evaporative Emission Purge Solenoid Valve

    • If within Specifications 
  5. All OK
scientia non olet · About LEMON Manuals